A most unique looking fountain that offers several interesting shapes, the 3 Tier Octagonal Fountain is made by artisan Klaus Kinast and features three sections of tapered tiers that fit within the round basin at the bottom. The durable and weather resistant concrete blocks and materials are all coated with a dark brown finish that adds color and protection to the concrete. The fountain is topped by a round ball and the water will gush out of this ball into the octagonal shaped basin beneath, and in turn the water will trickle down to the next largest and then finally spill over into the basin at the bottom. This fountain comes with the pump and you can set it up on a flat surface in your courtyard or patio for a long lasting decoration and a great work of art. Enjoy the soothing water sounds that will enrapture your guests. Suitable for outdoor use, made from proprietary blends of concrete and having unique weather resistant finishes applied. This line of concrete products is recognized for its exceptional quality of the castings and the finishes. Pump included.
Dimensions: H 54″ x W 48″ x D 48″
Weight: 800 lb (17 pieces)
Construction/ Finish: Concrete
Shipping / Special order: Shipping to Ottawa only. Shipping time is approximately 3 weeks.
Care InstructionsConcrete Fountain Care Instructions:
In cold climates all concrete outdoor statuary must be sealed. Sealing will protect the surface of the concrete from freezing and flaking, but will not keep a bowl or pond from cracking when frozen. ANY ITEM THAT HOLDS WATER MUST BE PROTECTED FROM FREEZING. Bowls and ponds can be inverted or covered and fountain pumps removed. By following these simple recommendations purchasers can easily and inexpensively protect their statuary from winter weather.
Protection Instructions during Freezing Weather
- Any piece that holds water (e.g., fountain and birdbath bowls) must be kept empty of water. There are several ways bowls can be kept dry. Birdbath bowls can be removed and placed inside. Larger bowls must be drained completely, left to dry several days and then covered to keep rain/snow out of the bowl. Large bowls may have both a drain plug that must be unscrewed and left open, and/or a rubber plug in the centre that should be removed (through which the pump cord passes.) The bowl (fountain) can then be covered with a tarp. Please note that condensation will form under plastic, wet the concrete and freeze. Therefore, all statuary must be water-sealed, even if covered.
- Pumps in small fountains that are easily removed should be drained and placed inside during freezing weather. Pumps in large fountains should be drained (plastic hose unhooked and pump emptied of water) and then elevated to prevent any accidental water from touching it. Place the pump up on a brick, or something similar, to keep it dry during the winter (Remember to remove the brick when refilling the fountain in the spring.) Please note that running submersible pumps out of the water will destroy them.
when filling a fountain or birdbath with water, never add water that is hotter or colder than the concrete. If the concrete is cold, add cold water. If the concrete is hot (has been sitting in the hot sun or inside a warm area), add only warm water. Otherwise, the concrete can crack.
- Prepare a proper base for your statuary. Because contact with the ground keeps statuary wet, fountains should be placed on a pad of concrete or brick to allow proper drainage and drying of the bottom of the piece. Otherwise, water will be "wicked" up from the ground into the concrete piece, even when there is no rain. Water-sealer liberally applied to the bottom of the piece also helps prevent this problem. Bench legs and bases of other pieces can be placed on stepping stones, crushed stone, gravel, brick, etc., to allow them to dry properly.