The Mulazzo Fountain looks much like the ancient fountains seen in Italy, and the beautiful accents and shapes of the column are enhanced greatly by the delightful finish on the concrete to create an antique look. The round basin has a hard plastic liner surrounded by a series of rounded concrete blocks that are lined to catch the spilling over water as it trickles down the column. The column itself features a slender bottom that tapers to a larger middle section where the scrollwork comes into prominence. The larger portion of the column is square and in the center of this square top basin is a round accent piece that creates visual contrast as well. The water is activated by an included pump and you can enjoy the sounds of water in your outdoor areas for many years, thanks to the durability of the materials. Designed by artisan Klaus Kinast, this concrete fountain will make your garden area better.
Suitable for outdoor use, made from proprietary blends of concrete and having unique weather resistant finishes applied. This line of concrete products is recognized for its exceptional quality of the castings and the finishes. Pump included.
Dimensions: H 48″ x W 48″ x D 48″
Weight: 650 lb (15 pieces)
Construction/ Finish: Concrete.
Shipping / Special order: Shipping to Ottawa only. Shipping time is approximately 3 weeks.
Care InstructionsConcrete Fountain Care Instructions:
In cold climates all concrete outdoor statuary must be sealed. Sealing will protect the surface of the concrete from freezing and flaking, but will not keep a bowl or pond from cracking when frozen. ANY ITEM THAT HOLDS WATER MUST BE PROTECTED FROM FREEZING. Bowls and ponds can be inverted or covered and fountain pumps removed. By following these simple recommendations purchasers can easily and inexpensively protect their statuary from winter weather.
Protection Instructions during Freezing Weather
- Any piece that holds water (e.g., fountain and birdbath bowls) must be kept empty of water. There are several ways bowls can be kept dry. Birdbath bowls can be removed and placed inside. Larger bowls must be drained completely, left to dry several days and then covered to keep rain/snow out of the bowl. Large bowls may have both a drain plug that must be unscrewed and left open, and/or a rubber plug in the centre that should be removed (through which the pump cord passes.) The bowl (fountain) can then be covered with a tarp. Please note that condensation will form under plastic, wet the concrete and freeze. Therefore, all statuary must be water-sealed, even if covered.
- Pumps in small fountains that are easily removed should be drained and placed inside during freezing weather. Pumps in large fountains should be drained (plastic hose unhooked and pump emptied of water) and then elevated to prevent any accidental water from touching it. Place the pump up on a brick, or something similar, to keep it dry during the winter (Remember to remove the brick when refilling the fountain in the spring.) Please note that running submersible pumps out of the water will destroy them.
when filling a fountain or birdbath with water, never add water that is hotter or colder than the concrete. If the concrete is cold, add cold water. If the concrete is hot (has been sitting in the hot sun or inside a warm area), add only warm water. Otherwise, the concrete can crack.
- Prepare a proper base for your statuary. Because contact with the ground keeps statuary wet, fountains should be placed on a pad of concrete or brick to allow proper drainage and drying of the bottom of the piece. Otherwise, water will be "wicked" up from the ground into the concrete piece, even when there is no rain. Water-sealer liberally applied to the bottom of the piece also helps prevent this problem. Bench legs and bases of other pieces can be placed on stepping stones, crushed stone, gravel, brick, etc., to allow them to dry properly.